Cladding Seal Installation Guide

Installation of Intumescent Cladding Seals

Fitting self adhesive cladding seal types:

Remove the release paper from the back of the strip: the strip can then be positioned in the required position on the face of the sheathing board and on top of any breathable membrane.

Tacks should be hammered along the centre line of the exposed face of the strip at approximately 250mm intervals to secure the seal in position.

The seal should be cut to the required length with a sharp knife and strip ends be butted together at the joins.

 

 

Fitting polythene encased cladding seal type:

Starting 125mm in from one end fix the back plate of the metal spike to your substrate at 250mm intervals.

Push the pre-cut to length seal onto the spike, taking care not to push hand or fingers onto the spike to avoid injury.

Fix the protective cover cap onto the spike.

Face the label outwards

 

 

 

The information in this publication is accurate to the best of the knowledge of Intuchem Ltd.

LEGAL:
As part of our policy of ongoing improvements, we reserve the right to modify, alter or change product specifications without giving notice. Product illustrations are representations only. All information contained in this document is provided for guidance only, and as Intuchem Ltd has no control over the installation methods of the products, or of the prevailing site conditions, no warranties expressed or implied are intended to be given as to the actual performance of the products mentioned or referred to, and no liability whatsoever will be accepted for any loss, damage or injury arising from the use of the information given of products mentioned or referred to herein.